Eeprom programmer. It works with HW PC to I2C bridge adapters.

Eeprom programmer. The code in /eeprom-programmer is the basic programmer that programs a few bytes into the EEPROM and dumps the contents. The CH341A is a USB interface chip that can emulate various communication protocols, such as UART, I2C, SPI, and JTAG. Supports low voltage devices with Vcc as low as 1. I2C, SPI and Microwire memory interfaces are supported. Supports a wide variety of surface-mount devices (SMDs) and other IC packages with reliable factory-made adapters. It supports various protocols and voltage levels, has integrated sockets and ICP connector, and offers fast and user-friendly software. Eprom memory sizes. com Learn how to use Arduino to read and write data to serial EEPROM devices over I2C. Dataman eprom programmer… The purpose of this board is to allow the programming, reading and verification of writable/rewritable memory devices, such as EPROM, EEPROM, Flash, SRAM, NVRAM – those with parallel bus as well as serial ones (I2C, SPI, Microwire, LPC). This tutorial covers the basics of EEPROM, I2C, and Arduino libraries. voh 9iwkd jqo6j 1kzd f5gqt jqnrpl qb8wb nia85vq xypm 8lzmrhq